Skip to content
Español

Training kit, $9

Dust control training PowerPoint

An editable 30-slide PowerPoint to run dust control training in about 40 minutes, with trainer notes, a trainer guide, a 10-question quiz, a sign-in sheet and a certificate. In English and Spanish.

Read the free talk
Slide 1 of 30 of the dust control PowerPoint: Dust control training

PREVIEW

Real slides from the deck

Six of the 30 slides, exactly as they open in PowerPoint. Tap one to see it larger.

1 of 6

Slide 1 of 30 of the dust control PowerPoint: Dust control training

What is in the kit

  • 30-slide editable PowerPoint with trainer notes on every slide
  • Trainer guide for a 40-minute class, with the agenda and the materials list
  • 10-question quiz and answer key
  • Crew handout with the dos and don'ts
  • Sign-in sheet and certificate of completion
  • Everything in English and Spanish, in one zip file

CONTENTS

What the slides cover, in order

The topics of the deck in the order you teach them, with the OSHA citation each slide carries. Then 10 quiz slides, one question each.

  1. Dust control training
  2. What you will learn today
  3. The hazard: dust you can see and dust you cannot
  4. Know what is in your dust · 29 CFR 1910.1200(b)(6)(iv)
  5. Rule group: control order for air contaminants · 29 CFR 1926.55(b)
  6. Rule group: silica Table 1 controls · 29 CFR 1926.1153(c)(1)
  7. Rule group: plan, competent person and training · 29 CFR 1926.1153(g)(1)
  8. Rule group: housekeeping · 29 CFR 1926.1153(f)(1)
  9. Rule group: respirators as backup · 29 CFR 1910.134(f)(2)
  10. How to do it right: before you start
  11. How to do it right: during the task and cleanup
  12. Dust control checklist
  13. Common mistakes
  14. Scenario exercise: the closed room
  15. Scenario debrief: what should have happened
  16. Recap
  17. Sign in before you go

TRAINER GUIDE

How the class runs

The trainer guide splits the 40 minutes like this. The notes on each slide say what to say.

Class agenda
MinutesWhat happens
4Welcome, sign-in, objectives and the hazard
5Know your dust and the control order
9The rules: Table 1, plan and competent person, housekeeping and respirators
8Doing it right: before, during, cleanup and the checklist
2Common mistakes
5Scenario exercise in small groups, then the debrief
1Recap
5Quiz: 10 questions, then go over the answers
1Closing: sign-in check, handouts and certificates

What you need

  • Slide deck on a screen or printed slides
  • The site's written exposure control plan, if it has one, and SDS binder or app
  • A tool with a water feed or shroud, and a HEPA vacuum if available
  • A respirator and a dust mask to compare
  • Printed quizzes, answer key and pens
  • Crew handouts, one per worker
  • Sign-in sheet and certificates of completion

Tips from the guide

  • Have a worker show the water feed or vacuum hookup on a real tool.
  • Look up the SDS together for a material the crew cuts often.
  • Say which rule applies, silica, air contaminants or respirators, each time you cite one.

QUIZ

3 of the 10 quiz questions

Pick your answer, then open it. The kit's answer key has them all.

  1. When a silica task on Table 1 uses a wet method, how much water must be applied?

    1. Just enough to cool the blade
    2. Enough flow to minimize release of visible dust
    3. None, if you wear a mask
    Show the answer

    B. Water must be applied at flow rates sufficient to minimize release of visible dust.

    29 CFR 1926.1153(c)(2)(ii)

  2. Where feasible, what should be used instead of dry sweeping silica dust?

    1. Compressed air
    2. Wet sweeping or a HEPA-filtered vacuum
    3. A leaf blower
    Show the answer

    B. The employer shall not allow dry sweeping or dry brushing where it could contribute to exposure, unless wet sweeping, HEPA vacuuming or similar methods are not feasible.

    29 CFR 1926.1153(f)(1)

  3. How often must a tight-fitting respirator be fit tested?

    1. Once, when hired
    2. Before first use, when a different facepiece is used and at least annually
    3. Never, if it feels snug
    Show the answer

    B. Fit testing is required prior to initial use, whenever a different respirator facepiece is used and at least annually.

    29 CFR 1910.134(f)(2)

PAPERWORK

Sign-in sheet, quiz and certificate

Ready to print. The certificate is a record of completion, not an OSHA card or license.

  • Sign-in sheet from the dust control kit

    Sign-in sheet

  • Quiz from the dust control kit

    Quiz

  • Certificate from the dust control kit

    Certificate

WHO IT IS FOR

Who it is for and how long it takes

For the supervisor, foreman or safety lead who has to train a crew on dust control and wants to walk in ready. The class takes about 40 minutes with the quiz. Run it in English or Spanish: the kit has both.

Used in: construction, manufacturing.

Only need a short talk? The 5-minute talk on this topic is free, in English and Spanish. Free dust control toolbox talk

OSHA standards cited in the kit

Each citation points to the paragraph of the rule in the eCFR. This is how the kit writes them:

Dust control training kit

$9

Pay once and download right away. No subscription. If it does not work for you, you get a refund within 30 days, no questions asked. Refund policy

See every training kit

Read the free talk first