Skip to content
Free sample
Español

Construction (29 CFR 1926) · Subpart I: Tools, hand and power

OSHA 1926.305: Jacks, lever and ratchet, screw, and hydraulic

29 CFR 1926.305 is titled "Jacks, lever and ratchet, screw, and hydraulic". It is part of Subpart I (Tools, hand and power) of the construction standards.

It has no paragraph that is mainly about training, but our talks cite it for what it requires on the job.

Official source: eCFR, 29 CFR 1926.305

TRAINING

Training requirements

This section has no paragraph that is mainly about training. It is listed here because our toolbox talks cite it.

TALKS

Toolbox talks and kits for this standard

Talks for this standard are being written now. Request a kit for this standard.

OFFICIAL TEXT

Full text: 29 CFR 1926.305

Official text of the federal regulation (public domain). Training paragraphs are shaded.

(a) General requirements. (1) The manufacturer's rated capacity shall be legibly marked on all jacks and shall not be exceeded.

(2) All jacks shall have a positive stop to prevent overtravel.

(b) [Reserved]

(c) Blocking. When it is necessary to provide a firm foundation, the base of the jack shall be blocked or cribbed. Where there is a possibility of slippage of the metal cap of the jack, a wood block shall be placed between the cap and the load.

(d)(1) Operation and maintenance. (i) After the load has been raised, it shall be cribbed, blocked, or otherwise secured at once.

(ii) Hydraulic jacks exposed to freezing temperatures shall be supplied with an adequate antifreeze liquid.

(iii) All jacks shall be properly lubricated at regular intervals.

(iv) Each jack shall be thoroughly inspected at times which depend upon the service conditions. Inspections shall be not less frequent than the following:

(a) For constant or intermittent use at one locality, once every 6 months,

(b) For jacks sent out of shop for special work, when sent out and when returned,

(c) For a jack subjected to abnormal load or shock, immediately before and immediately thereafter.

(v) Repair or replacement parts shall be examined for possible defects.

(vi) Jacks which are out of order shall be tagged accordingly, and shall not be used until repairs are made.

KEEP READING

More from Subpart I